tag:blogger.com,1999:blog-7352328927235200435.post6381424587282655643..comments2023-12-11T02:24:59.133-06:00Comments on The greasy shop rag: Workshop Wednesday-Evening EditionScott Seidlhttp://www.blogger.com/profile/17244490864200031268noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-7352328927235200435.post-23024942980300694262014-02-19T21:51:02.963-06:002014-02-19T21:51:02.963-06:00One was on a fork lift the other on a snow plow. I...One was on a fork lift the other on a snow plow. I've decided the reason for failure is the fact the wires going to the fuse are allowed to flex. One was a 4 amp, the other ten. When the wires flex, the terminals flex side to side. This breaks the small wire fuses.Scott Seidlhttps://www.blogger.com/profile/17244490864200031268noreply@blogger.comtag:blogger.com,1999:blog-7352328927235200435.post-54854111138358292592014-02-19T20:51:09.921-06:002014-02-19T20:51:09.921-06:00Are the forklifts the same brand? Maybe the type o...Are the forklifts the same brand? Maybe the type of fuses they used from the factory are prone to that type of failure. Maybe operating vibration causes it? At least you found it quicker on take two. JBMFThttps://www.blogger.com/profile/15700360014302536945noreply@blogger.com